northvale korting - specialists in flow control equipment
Sunday 23rd April 2017

Northvale Korting Ltd
2 Uxbridge Road
Leicester LE4 7ST

Tel: + 44 (0) 116 266 5911

Tilting Disc Check - Limitations

Tilting Disc Check Valves OperationApplies for all tilting disc check valves.

In some installations check valves may require special attention to function satisfactorily.

1. Small pulsating gas flows

The tilting disc check valve opens quickly for a low differential pressure. It also closes very quickly when the differential pressure lessens. If the flow pulsates and is so low that the tilting disc check valve is not fully open, the valve disc may flutter resulting in unnecessary wear. Piston compressors and steam digesters for direct infusion of steam to heat water are examples of components that may give difficult pulsations.

Remedy: Is the flow large enough to eliminate the risk of flutter with a valve of full pipe size? If not, choose a smaller valve so that it will be fully open in all normal operation cases.

2. Low pressure gases – vacuum

The opening dynamic force is affected by density. A low pressure gas requires a larger flow that a high pressure gas to fully open the tilting disc check valve.

Remedy: Make certain that the available differential pressure, flow velocity and density are adequate.

3. Location on suction side of centrifugal pumps

A centrifugal pump has certain pressure requirements on the suction side (NPSH) to be able to start pumping and avoid cavitation. The pump manufacturers recommend an open pipe on the suction side.

Remedy: Place the check valve behind the pump. Even though a tilting disc check valve opens easily, it will reduce the suction pressure if placed on the suction side.

4. Pumps in parallel

Attempts to start the second of two pumps in parallel having rising QH-curve, while the first pump is still working, will result in the tilting disc check valve not opening. The pressure behind the check valve will be higher than in front of it.

Remedy: Make certain that the pump characteristics fall the entire flow range. Otherwise special measures such as throttling and shunting will be necessary.

5. Downward flow

Tilting disc check valves – as well as swing check valves and other tilting disc swing check valves – are intended to be mounted in horizontal lines or vertical lines with upward flow. The valve can also be installed in oblique lines with upward flow but installation in lines with downward flow should be avoided.

Product Range
 
Registered Office:
The Farm House, Vantage Business Park,
Bloxham Road, Banbury, Oxfordshire, OX16 9UX

Registered in England No. ­02091066
VAT Registration No. GB ­459 9212 13
Copyright © 2009-2017 Northvale Korting Ltd.
All Rights Reserved.       Website by Metropolis2